2012 Gasoline Peace, mercy, and blessings of God be upon you. Caprice 2012, white – 6.2 modified project. The car is an ongoing and costly project. The engine is built with performance parts, with attention to cooling, lubrication, and suspension. The project is guaranteed complete up to the stage of starting it, dyno testing, and final tuning. All that remains is to complete the exhaust system, dyno testing, and final programming. 🔥 Engine and Project 6.2 block with pistons Original 6.2 heads Mahle coated bearings Mahle (or Mahali, as they call it) rings Crankshaft is not conical Texas Speed Stage 3 Silent Cam BTR lifters Double springs + pushrods + valves + valve seals all Texas Speed Performance timing chain GM gaskets and head gaskets Original coolant Melling high-pressure oil pump, pressure is excellent, praise be to God. The DOD is mechanically deleted. Fans are programmed. All parts were installed by Ali Al-Nafisa at Mustaqbal Al-Motor workshop in Al-Rimal. I disassembled it when it was new, by my own hands. Parts were sourced from LS Series in Dammam and Bahrain. Complete engine harness insulation with good insulation. It has a full exhaust system from the headers to the end. It was programmed for startup by Al-Zeer. Al-Muaiqal machine shop in the old industrial area is well-known. ❄ Cooling Aluminum radiator with Nissan cap and thermostat. New fan motor. USMN water pump, not long ago, and its condition is excellent. GM coolant hoses (upper and lower) with grommets, all original from Rashed Al-Subaie. Temperature is guaranteed not to exceed 95 degrees, even in heavy traffic and during the day, praise be to God. 🔧 Suspension and Maintenance Original GM front strut mounts. Original rear differential bushings and control arm bushings from Rashed Al-Subaie. Four new shock absorbers. New GM driveshaft carrier bearing. New GM crankshaft pulley. Clean 100% GM fuse box, taken from a junkyard. Alternator replaced, and its condition is good. Transmission is sound, oil changed at Badil using a machine, with Lucas additive and two flush cycles. Air conditioning is excellent, praise be to God, it's like ice. 🚗 Body and Rims Chassis is sound, with a very minor scratch on the left side, not affecting it at all. Body has been repainted. Four original GM rims, model 13. Right fender replaced from a junkyard and needs repainting. Grille is in the trunk. Original GM hood is available but I haven't had time to install it. Front windshield replaced from Al-Salem a long time ago. Observations, with all honesty: Front suspension needs a few parts. Right fender needs repainting. Grille and hood are available and need installation. The project still needs completion of the exhaust system, dyno testing, and final programming. Asking price: 50,000 And God is the grantor of success.